Tradeweld Floor Kit Pro is used for the repair of delaminated floors in Caravans,
Motor Homes, Statics, and Commercial Vehicles. By drilling a series of holes through
the top of the floor it is possible to inject the adhesive and the panel is then
pressed or clamped until cure has taken place. If delamination has occurred at an
edge it may be possible to lift the facing slightly and apply the adhesive with
a spatula.
Floor Kit Pro has been designed specifically for application by injection through
a nozzle or hollow needle and then flows readily to fill the volume or gap into
which it has been injected.
Tradeweld Floor Kit Pro is a two part, 100% solids, low viscosity, fast cure
epoxy based adhesive. The product has a reasonable pot life for ease of use, but
will be tack free overnight at 15°C. Although lower temperatures will slow the cure,
Tradeweld Floor kit Pro will continue to cure at temperatures close to freezing point.
The low volatility of the Resins and curing agent mean that the kit will be of a
low odour for greater user comfort.
Being a 100% solids material it will cure in totally enclosed spaces and since
it contains no solvent it will not attack sensitive plastics e.g. polystyrene.
Tradeweld Floor Kit Pro may also be used for conventional bonding processes
where an epoxy type is required and low viscosity is an advantage.
For application from underneath the floor use Tradeweld DeLam TX.
Instructions Sheet
Technical Datasheet
Part A Material Safety Datasheet
Part B Material Safety Datasheet
Please Note:
Although we sell hundreds of delaminations kits each year; we are adhesive specialists
and not caravan repairers and can only offer general advice on repairing your caravan.
If you have any concerns regarding the repair of your caravan we strongly recommend you
consult a qualified repairer prior to undertaking any work yourself.
8mm wooden dowells are required to plug the holes, these can be obtained from
most hardware stores.